Sftp Configuration - H3C S5100-SI Series Operation Manual

Operation Manual – FTP-SFTP-TFTP
H3C S5100-SI/EI Series Ethernet Switches
# Execute the get command to download the file named switch.bin to the Flash
memory of the switch.
[ftp] get switch.bin
# Execute the quit command to terminate the FTP connection and return to user view.
[ftp] quit
<Sysname>
# After downloading the file, use the boot boot-loader command to specify the
downloaded file (switch.bin) to be the application for next startup, and then restart the
switch. Thus the switch application is upgraded.
<Sysname> boot boot-loader switch.bin
<Sysname> reboot
Note:
For information about the boot boot-loader command and how to specify the startup
file for a switch, refer to the System Maintenance and Debugging module of this
manual.

1.3 SFTP Configuration

Complete the following tasks to configure SFTP:
SFTP Configuration: A
Switch Operating as an
SFTP Server
SFTP Configuration: A
Switch Operating as an
SFTP Client
Chapter 1 FTP and SFTP Configuration
Task
Enabling an SFTP server
Configuring connection idle time
Supported SFTP client software
Basic configurations on an SFTP
client
Specifying the source interface or
source IP address for an SFTP
client
1-16
Remarks
Required
Optional
—
—
Optional