Duplicating The Configuration Of A Port To Other Ports - H3C S5100-SI Series Operation Manual

Operation Manual – Port Basic Configuration
H3C S5100-SI/EI Series Ethernet Switches
The peer switch will stop sending packets to the local switch or reduce the sending
rate temporarily when it receives the message; and vice versa. By this way, packet
loss is avoided and the network service operates normally.
Follow these steps to enable flow control on a port:
Enter system view
Enter Ethernet port view
Enable flow control on the
Ethernet port

1.1.6 Duplicating the Configuration of a Port to Other Ports

To make other ports have the same configuration as that of a specific port, you can
duplicate the configuration of a port to specific ports.
Specifically, the following types of port configuration can be duplicated from one port to
other ports: VLAN configuration, protocol-based VLAN configuration, LACP
configuration, QoS configuration, GARP configuration, STP configuration and initial
port configuration. Refer to the command manual for the configurations that can be
duplicated.
Follow these steps to duplicate the configuration of a port to specific ports:
To do...
Enter system view
Duplicate the
configuration of a
port to specific ports
Note:
If you specify a source aggregation group ID, the system will use the port with the
smallest port number in the aggregation group as the source.
If you specify a destination aggregation group ID, the configuration of the source
port will be copied to all ports in the aggregation group and all ports in the group will
have the same configuration as that of the source port.
To do...
system-view
interface interface-type
interface-number
flow-control
system-view
copy configuration source
{ interface-type interface-number |
aggregation-group source-agg-id }
destination { interface-list
[ aggregation-group destination-agg-id ] |
aggregation-group destination-agg-id }
Use the command...
Use the command...
1-5
Chapter 1 Port Basic Configuration
Remarks
—
—
By default, flow control is
not enabled on the port.
Remarks
—
Required