Displaying Source Ip Address Configuration - H3C S5100-SI Series Operation Manual

Operation Manual – Login
H3C S5100-SI/EI Series Ethernet Switches
II. Configuration in system view
Table 8-2 Configure a source IP address for service packets in system view
Specify a source IP
address for Telnet server
Specify a source interface
for Telnet server
Specify source IP address
for Telnet client
Specify a source interface
for Telnet client
Note:
To perform the configurations listed in
The IP address specified is that of the local device.
The interface specified exists.
If a source IP address (or source interface) is specified, you need to make sure that
the route between the IP addresses (or interface) of both sides is reachable.

8.3 Displaying Source IP Address Configuration

Execute the display command in any view to display the operation state after the
above configurations. You can verify the configuration effect through the displayed
information.
Table 8-3 Display the source IP address configuration
Display the source IP address
configured for the Telnet client
Display the source IP address
configured for the Telnet server
Operation
Operation
Chapter 8 Configuring Source IP Address for
Command
telnet-server source-ip ip-address
telnet-server source-interface
interface-type interface-number
telnet source-ip ip-address
telnet source-interface
interface-type interface-number
Table 8-1 and
Command
display telnet
source-ip
display telnet-server
source-ip
8-2
Telnet Service Packets
Description
Optional
Optional
Optional
Optional
Table 8-2, make sure that:
Description
You can execute the
two commands in any
view.