Dldp Configuration; Performing Basic Dldp Configuration - H3C S5100-SI Series Operation Manual

Operation Manual – DLDP
H3C S5100-SI/EI Series Ethernet Switches
V. DLDP neighbor state
A DLDP neighbor can be in one of these two states: two way and unknown. You can
check the state of a DLDP neighbor by using the display dldp command.
Table 1-7 Description on the two DLDP neighbor states
DLDP neighbor state
Two way
Unknown

1.2 DLDP Configuration

1.2.1 Performing Basic DLDP Configuration

Follow these steps to perform basic DLDP configuration:
Enter system view
Enable
DLDP
Set the authentication mode and
password
Set the interval of sending DLDP
packets
Set the delaydown timer
Set the DLDP handling mode
when an unidirectional link is
detected
To do ...
Enable DLDP globally
Enable Enter Ethernet
DLDP port view
on a
Enable DLDP
port
Description
The link to the neighbor operates properly.
The device is detecting the neighbor and the
neighbor state is unknown.
Use the command ...
system-view
dldp enable
interface interface-type
interface-number
dldp enable
dldp authentication-mode
{ none | simple
simple-password | md5
md5-password }
dldp interval timer-value
dldp delaydown-timer
delaydown-time
dldp
unidirectional-shutdown
{ auto | manual }
1-7
Chapter 1 DLDP Configuration
Remarks
—
Required.
By default,
DLDP is
disabled.
Optional.
By default, the
authentication
mode is none.
Optional.
By default, the
interval is 5
seconds.
Optional
By default, the
delaydown
timer expires
after 1 second
it is triggered.
Optional.
By default, the
handling mode
is auto.