Configuring Traffic Policing - H3C S5100-SI Series Operation Manual

[Sysname-acl-basic-2000] rule permit source 10.1.1.0 0.0.0.255
[Sysname-acl-basic-2000] quit
[Sysname] traffic-priority vlan 2 inbound ip-group 2000 dscp 56

1.4.6 Configuring Traffic Policing

Refer to
Note:
This feature is available only for the H3C S5100-EI series switches.
I. Configuration prerequisites
The ACL rules used for traffic classification have been defined. Refer to the ACL
module of this manual for information about defining ACL rules.
The rate limit for traffic policing and the actions for the packets exceeding the rate
limit have been determined.
II. Configuration procedures
You can configure traffic policing for the incoming packets matching the specific ACL
rules globally, in a VLAN, in a port group, or on a port.
1) Configuring traffic policing globally
Follow these steps to configure traffic policing for the incoming packets matching the
specific ACL rules globally:
To do...
Enter system
view
Configure traffic
policing
Clear traffic
policing statistics
2) Configuring traffic policing for a VLAN
Follow these steps to configure traffic policing for the incoming packets matching the
specific ACL rules in a VLAN:
Traffic Policing and Traffic Shaping
system-view
traffic-limit inbound acl-rule target-rate
[ conform con-action ] [ exceed
exceed-action ] [ meter-statistic ]
reset traffic-limit inbound acl-rule
for information about traffic policing.
Use the command...
1-29
Remarks
—
Required
Disabled by default.
Optional