Dhcp Test - H3C S5100-SI Series Operation Manual

Operation Manual – HWPing
H3C S5100-SI/EI Series Ethernet Switches
[Sysname-hwping-administrator-icmp] display hwping history administrator
icmp
HWPing entry(admin administrator, tag icmp) history record:
Index
For detailed output description, see the corresponding command manual.

1.3.2 DHCP Test

I. Network requirements
Both the HWPing client and the DHCP server are H3C S5100-SI/EI series Ethernet
switches. Perform a HWPing DHCP test between the two switches to test the time
required for the HWPing client to obtain an IP address from the DHCP server.
II. Network diagram
Figure 1-3 Network diagram for the DHCP test
III. Configuration procedure
Configure DHCP Server(Switch B):
Configure DHCP server on Switch B. For specific configuration of DHCP server, refer to
the DHCP part of the manual.
Configure HWPing Client (Switch A):
# Enable the HWPing client.
<Sysname> system-view
[Sysname] hwping-agent enable
# Create a HWPing test group, setting the administrator name to administrator and
test tag to DHCP.
[Sysname] Hwping administrator dhcp
# Configure the test type as dhcp.
[Sysname-hwping-administrator-dhcp] test-type dhcp
Response Status
1 3
2 4
3 4
4 3
5 3
Chapter 1 HWPing Configuration
LastRC
1 0 2000-04-02 20:55:12.3
1 0 2000-04-02 20:55:12.3
1 0 2000-04-02 20:55:12.2
1 0 2000-04-02 20:55:12.2
1 0 2000-04-02 20:55:12.2
1-20
Time