H3C S5100-SI Series Operation Manual page 553

Operation Manual – Stack-Cluster
H3C S5100-SI/EI Series Ethernet Switches
Configure the port forward
delay of topology
collection requests
Configure the interval to
collect topology
information periodically
Quit system view
Launch topology
information collection
manually
VI. Enabling the cluster function
Table 2-8 Enable the cluster function
Enter system view
Enable the cluster
function globally
VII. Configuring cluster parameters
The establishment of a cluster and the related configuration can be accomplished in
manual mode or automatic mode, as described below.
1) Establishing a cluster and configuring cluster parameters in manual mode
Table 2-9 Establish a cluster and configure cluster parameters in manual mode
Enter system view
Specify the management
VLAN
Enter cluster view
Configure a IP address
pool for the cluster
Operation
ntdp timer port-delay
time
ntdp timer
interval-in-minutes
quit
ntdp explore
Operation
system-view
cluster enable
Operation
system-view
management-vlan
vlan-id
cluster
ip-pool
administrator-ip-address
{ ip-mask |
ip-mask-length }
Command
Command
Command
2-13
Chapter 2 Cluster
Description
Optional
By default, the port
forward delay is 20 ms.
Optional
By default, the topology
collection interval is one
minute.
—
Optional
Description
—
Required
By default, the cluster
function is enabled.
Description
—
Required
By default, VLAN 1 is
used as the management
VLAN.
—
Required