Configuring The User Interfaces For Ssh Clients - H3C S5100-SI Series Operation Manual

Operation Manual – SSH
H3C S5100-SI/EI Series Ethernet Switches
Note:
The SSH server needs to cooperate with an SSH client to complete the interactions
between them. For SSH client configuration, refer to

1.3.1 Configuring the User Interfaces for SSH Clients

An SSH client will access the device through a terminal "VTY" user interface. Therefore,
you need to configure the device user interface to accept SSH clients and allow SSH
login. Note that the configuration takes effect at the next login.
Table 1-3 Follow these steps to configure the device user interface for SSH clients:
Enter system view
Enter user interface view
of one or more user
interfaces
Configure the
authentication mode as
scheme
Specify the supported
protocol(s)
Caution:
If you have configured a user interface to support SSH protocol, you must configure
AAA authentication for the user interface by using the authentication-mode
scheme command to ensure successful login.
On
authentication-mode none command has been executed, the protocol inbound
ssh command is not available. Similarly, if the protocol inbound ssh command
has
authentication-mode none commands are not available.
To do...
system-view
user-interface vty
first-number
[ last-number ]
authentication-mode
scheme
[ command-authorizatio
n ]
protocol inbound { all
|ssh }
a user interface,
been executed,
Configuring the SSH
Use the command...
if the authentication-mode
the authentication-mode
1-8
Chapter 1 SSH Configuration
Client.
Remarks
—
—
Required
By default, the user
interface authentication
mode is password.
Optional
By default, both Telnet
and SSH are supported.
password
password
or
and