Modem Connection Establishment - H3C S5100-SI Series Operation Manual

Operation Manual – Login
H3C S5100-SI/EI Series Ethernet Switches

4.3 Modem Connection Establishment

1) Before using Modem to log in the switch, perform corresponding configuration for
different authentication modes on the switch. Refer to
Configuration with Authentication Mode Being
Configuration with Authentication Mode Being
Configuration with Authentication Mode Being Scheme
2) Perform the following configuration to the modem directly connected to the switch.
Refer to
3) Connect your PC, the modems, and the switch, as shown in
the modems are properly connected to telephone lines.
Telephone line
Modem
Console port
Figure 4-1 Establish the connection by using modems
4) Launch a terminal emulation utility on the PC and set the telephone number to call
the modem directly connected to the switch, as shown in
Figure
directly connected to the switch.
Modem Configuration
Modem serial cable
PSTN
Telephone number
of the romote end:
82882285
4-4. Note that you need to set the telephone number to that of the modem
Chapter 4 Logging In Using a Modem
Password, and
for related configuration.
Modem
4-3
Console Port Login
None, Console Port Login
Console Port Login
for more.
Figure 4-1. Make sure
Figure 4-2 through