Establishing An Http Connection - H3C S5100-SI Series Operation Manual

Operation Manual – Login
H3C S5100-SI/EI Series Ethernet Switches
Chapter 6 Logging In Through the Web-based
Network Management Interface
Go to these sections for information you are interested in:
Introduction

Establishing an HTTP Connection

Configuring the Login Banner
Enabling/Disabling the WEB Server
6.1 Introduction
An S5100-SI/EI Ethernet switch has a Web server built in. It enables you to log in to an
S5100-SI/EI Ethernet switch through a Web browser and then manage and maintain
the switch intuitively by interacting with the built-in Web server.
To log in to an S5100-SI/EI Ethernet switch through the built-in Web-based network
management interface, you need to perform the related configuration on both the
switch and the PC operating as the network management terminal.
Table 6-1 Requirements for logging in to a switch through the Web-based network
management system
Item
Switch
PC operating
as the network
management
terminal
6.2 Establishing an HTTP Connection
1) Assign an IP address to VLAN-interface 1 of the switch (VLAN 1 is the default
VLAN of the switch). See
information.
2) Configure the user name and the password on the switch for the Web network
management user to log in.
The VLAN interface of the switch is assigned an IP address, and
the route between the switch and the Web network management
terminal is reachable. (Refer to the IP Address Configuration – IP
Performance Configuration and Routing Protocol parts for related
information.)
The user name and password for logging in to the Web-based
network management system are configured.
IE is available.
The IP address of the VLAN interface of the switch, the user
name, and the password are available.
Telnetting to a Switch from a Terminal
6-1
Chapter 6 Logging In Through the Web-based
Network Management Interface
Requirement
for related