H3C S5100-SI Series Operation Manual page 760

Operation Manual – Information Center
H3C S5100-SI/EI Series Ethernet Switches
Output
direction
Log host
Trap
buffer
Log
buffer
SNMP
NMS
II. Enabling system information display on the console
After setting to output system information to the console, you need to enable the
associated display function to display the output information on the console.
Follow these steps to enable the system information display on the console:
Enable the debugging/log/trap
information terminal display
function
Enable debugging information
terminal display function
Enable log information
terminal display function
Enable trap information
terminal display function
Note:
Make sure that the debugging/log/trap information terminal display function is enabled
(use the terminal monitor command) before you enable the corresponding terminal
display function by using the terminal debugging, terminal logging, or terminal
trapping command.
LOG
Modules
Enabl
allowed
ed/dis
abled
default
Enabl
(all
ed
modules)
default
Disabl
(all
ed
modules)
default
Enabl
(all
ed
modules)
default
Disabl
(all
ed
modules)
To do...
TRAP
Enable
Severi Severit
d/disab
ty
led
inform Enable debuggi
ational d ng
inform Enable warning
ational d s
warnin Disable debuggi
gs d ng
debug Enable warning
ging d s
Use the command...
terminal monitor
terminal debugging
terminal logging
terminal trapping
1-11
Chapter 1 Information Center
DEBUG
Enable
Severit
d/disab
y
led
Disable debuggi
d ng
Disable debuggi
d ng
Disable debuggi
d ng
Disable debuggi
d ng
Remarks
Optional
Enabled by default.
Optional
Disabled by default.
Optional
Enabled by default.
Optional
Enabled by default.
y