H3C S5100-SI Series Operation Manual page 874

Operation Manual – Smart Link-Monitor Link
H3C S5100-SI/EI Series Ethernet Switches
# Configure to send flush messages within VLAN 1.
[SwitchA-smlk-group1] flush enable control-vlan 1
2) Enable the function of processing flush messages received from VLAN 1 on
Switch C.
# Enter system view.
<SwitchC> system-view
# Enable the function of processing flush messages received from VLAN 1 on
GigabitEthernet 1/0/2.
<SwitchC> smart-link flush enable control-vlan 1 port GigabitEthernet 1/0/2
3) Enable the function of processing flush messages received from VLAN 1 on
Switch D.
# Enter system view.
<SwitchD> system-view
# Enable the function of processing flush messages received from VLAN 1 on
GigabitEthernet 1/0/2.
[SwitchD] smart-link flush enable control-vlan 1 port GigabitEthernet 1/0/2
4) Enable the function of processing flush messages received from VLAN 1 on
Switch E.
# Enter system view.
<SwitchE> system-view
# Enable the function of processing flush messages received from VLAN 1 on
GigabitEthernet 1/0/2 and GigabitEthernet 1/0/3.
[SwitchE] smart-link flush enable control-vlan 1 port GigabitEthernet 1/0/2
to GigabitEthernet 1/0/3
Chapter 1 Smart Link Configuration
1-9