H3C S5100-SI Series Operation Manual page 73

Operation Manual – Login
H3C S5100-SI/EI Series Ethernet Switches
configured by the header command, a user logging in through Web directly enters the
user login authentication page.
Follow these steps to configure the login banner:
Enter system view
Configure the banner to
be displayed when a
user logs in through Web
6.3.2 Configuration Example
I. Network requirements
A user logs in to the switch through Web.
The banner page is desired when a user logs into the switch.
II. Network diagram
Figure 6-3 Network diagram for login banner configuration
III. Configuration Procedure
# Enter system view.
<Sysname> system-view
# Configure the banner Welcome to be displayed when a user logs into the switch
through Web.
[Sysname] header login %Welcome%
Assume that a route is available between the user terminal (the PC) and the switch.
After the above-mentioned configuration, if you enter the IP address of the switch in the
address bar of the browser running on the user terminal and press <Enter>, the
browser will display the banner page, as shown in
To do...
system-view
header login text
Chapter 6 Logging In Through the Web-based
Use the command...
Figure
6-3
Network Management Interface
Remarks
—
Required
By default, no login
banner is configured.
6-4.