Cli Views - H3C S5100-SI Series Operation Manual

Operation Manual – Login
H3C S5100-SI/EI Series Ethernet Switches
<Sysname> super 3
Password:
User privilege level is 3, and only those commands can be used
whose level is equal or less than this.
Privilege note: 0-VISIT, 1-MONITOR, 2-SYSTEM, 3-MANAGE
# After configuring the switch, the general user switches back to user level 0.
<Sysname> super 0
User privilege level is 0, and only those commands can be used
whose level is equal or less than this.
Privilege note: 0-VISIT, 1-MONITOR, 2-SYSTEM, 3-MANAGE

5.3 CLI Views

CLI views are designed for different configuration tasks. They are both correlated and
distinguishing. For example, once a user logs into a switch successfully, the user enters
user view, where the user can perform some simple operations such as checking the
operation status and statistics information of the switch. After executing the
system-view command, the user enters system view, where the user can go to other
views by entering corresponding commands.
Table 5-3
operations that can be performed in different CLI views and the commands used to
enter specific CLI views.
Table 5-3 CLI views
View
User view
System
view
lists the CLI views provided by S5100-SI/EI series Ethernet switches,
Available
operation
Display operation
status and
statistical
information of the
switch
Configure system
parameters
Prompt
Enter method
example
Enter user view
<Sysname> once logging
into the switch.
Execute the
system-view
[Sysname]
command in
user view.
5-5
Chapter 5 CLI Configuration
Quit
method
Execute the
quit
command to
log out of the
switch.
Execute the
quit or
return
command to
return to user
view.