Paging And Announcement Equipment; Hooking Up Loudspeaker Paging From A G450 Media Gateway - Avaya G450 Installing And Upgrading

Paging and announcement equipment

This section provides information on loudspeaker paging.
On a G450 Media Gateway, the loudspeaker paging feature is connected through a port on an
MM711 Analog Media Module. The port is administered on the SAT Station screen, not the
Loudspeaker Paging screen.
The G450 Media Gateway does not support an auxiliary trunk circuit pack. Therefore, the
loudspeaker feature through an auxiliary trunk is not supported on a G450 Media Gateway.
Users on a G450 Media Gateway controlled by an S8700-series or S8500 can also access the
loudspeaker paging feature if equipment is physically connected to a TN763 auxiliary trunk
circuit pack in an PN carrier of an the S8700-series or S8500 system.
Figure 157 shows the connections for loudspeaker paging, dial dictation, or recorded
announcement features on a G450 Media Gateway.

Hooking up loudspeaker paging from a G450 Media Gateway

Figure 157: Typical loudspeaker equipment connections for a G450 Media Gateway
Figure notes:
1. G450 Media Gateway
2. Universal Paging access module
3. RJ-45 connection
1. Connect one end of an RJ-45 cable to a port in the MM711 Analog Media Module.
2. Connect the other end of the RJ-45 cable to a customer-supplied telephone hybrid device.
3. Follow the manufacturer's instructions to properly connect the telephone hybrid device to
your loudspeaker paging system.
4. Administer the M711 port on the SAT Station screen as an analog station.
MDM USB
CONSOLE SERVICES ETR CCA ETH WAN ETH LAN
ALM COMPACT FLASH
CPU
PWR
1 3 4 5 6
1 2 CARD IN USE 2
V10
V1 V5
V2 V6
V3 V7
V4 V8

Paging and announcement equipment

G450
RST ASB
4. Telephone hybrid (third party)
device
5. Loudspeaker paging system
Issue 2 June 2008 285