Installation/Removal Procedure; Processor (Cpu) - NEC BladeServer Express5800 Series User Manual

INSTALLATION/REMOVAL PROCEDURE

Install or remove optional devices in the following procedures:

Processor (CPU)

The server may have another CPU installed in addition to the factory-installed CPU (Dual-Core
Intel Xeon Processor or Quad-Core Intel Xeon Processor).
IMPORTANT:
The second CPU must have the same specifications (core voltage,
clock, etc.) as the factory-installed CPU.
The CPU is extremely sensitive to static electricity. Make sure to
touch the metal frame of the server to discharge static electricity
from your body before handling the CPU. Do not touch the CPU
pins with your bare hands or place the CPU directly on a desk. For
static notes, see the section "Anti-static Measures" described earlier.
Do not operate the system until confirming that the second CPU is
in the normal state.
Make sure to use a CPU authorized by NEC. Installing a third-party
CPU may cause a failure of the CPU as well as the server. Repair
costs of the server due to damage resulting from installation of such
a CPU will be charged even within the warranty period.
CPU #1 (to be installed below the heat sink)
CPU #2 (to be installed below the dummy heat sink)
CPU blade
Upgrading Your Server 9-5