Notification Of Call From The Remote Station By Vibration Of The Vibrator; Selecting Vibrator Operation Mode - Yaesu FT1DR Operating Manual

Using the Tone Squelch Function
Notification of Call from the Remote Station by
Vibration of the Vibrator
Set the vibrator to alert you of a call from a remote station containing a corresponding
CTCSS tone or DCS code.
Enter the Set mode:
Press and hold M over 1 second.
1
Turn O to select [8 CONFIG].
2
Press H.
3
Turn O to select [22 VIBRATOR].
4
Press H.
5
Turn O to select [MODE].
6
Press H.
7
Turn O to select [SIGNALING].
8
Press p to set the Vibrator mode and exit the Set mode.
9
Tip To turn off the Vibrator function, select [OFF] in step 7.
Tips
• The vibrator function can be set for all frequency bands belonging to A-band (Main) and B-band
(Sub).
• Selecting [8 CONFIG]
then [BUSY] for [MODE] in the Set mode will cause the vibrator to
start vibrating when the BUSY LED lights upon reception of a
signal.
• If the BUSY state is not held continuously over 5 seconds, the
suspended state is canceled.
If the p switch is operated to change the communication mode from transmission to reception
when the vibrator is turned ON, the vibrator function is turned off for 5 seconds.

Selecting Vibrator Operation Mode

Enter the Set mode:
Press and hold M over 1 second.
1
Turn O to select [8 CONFIG].
2
Press H.
3
Turn O to select [22 VIBRATOR].
4
Press H.
5
88
[22 VIBRATOR] [MODE] and