Performing Programmable Memory Channel Scan - Yaesu FT1DR Operating Manual

Using the Scanning Function

Performing Programmable Memory Channel Scan

The programmable memory channel scan allows you to scan a specified frequency
range within the same frequency band.
1
Switch to the Memory mode.
Recall a PMS memory channel to which the lower limit
frequency or upper limit frequency is registered.
Press F and then 2.
2
Programmable memory channel scanning starts.
• Turn O clockwise: Scanning is performed toward higher
Tips
Turn O counterclockwise: Scanning is performed toward
• When a signal is received during scanning, scanning stops for
5 seconds and this frequency is received.
• When scanning is suspended, the decimal point blinks and the LCD stays lit.
• After receiving the frequency for 5 seconds, scanning resumes.
• To stop scanning, press p.
Tips
• When a skip memory channel is specified for [L½] or [U½] or when the lower/upper limit frequency
is not properly specified, program memory channel scanning is not performed properly.
• Press and hold M over 1 second to select the Set mode option and then select the following
setting items for more convenient use:
[8 CONFIG] [3 BEEP]
[5 SCAN] [2 SCAN LAMP]: Prevents the LCD from being lit when scanning stops.
• Even during scanning, you can adjust the squelch in the following procedure:
Press F Press T
• During scanning, you can finish the squelch adjustment in the following procedure:
Press F Press T.
64
frequencies.
lower frequencies.
[EDGE]: Emits a beep when the frequency band edge is reached.
Turn O to adjust the squelch.
Decimal point blinks.