Registering To Memory Channel - Yaesu FT1DR Operating Manual

Registering to Memory Channel

Caution
The information such as operating frequency that is registered to memory channels can be corrupted
due to wrong operation, static electricity, or electrical noise. Also, it can be erased in the case of a
failure or repair. Be sure to write it down on paper or otherwise save the information (See pages 137
to 138).
The transceiver allows you to use 900 memory channels (memory channel numbers 1
to 900).
1
Switch to the VFO mode.
Tune in to a frequency by turning O.
2
Select the frequency you want to register to a memory
channel.
Press and hold F over 1 second.
3
Enters the Memory Channel Registration mode, and
the number of the memory channel next to the memory
channel to which you registered a frequency last blinks.
• To cancel the memory channel registration, press the p
Remarks
switch.
• To register a frequency to a memory channel specified, Turn O to select the memory
channel.
The ( icon indicating [The specified memory channel is unregistered] lights, and the
memory channel blinks.
The ) icon indicating [The specified memory channel is registered] lights.
• Pressing M each time skips memory channels quickly in steps of 100 memory
channels.
Press F to complete the memory channel registration. The registered frequency
4
appears on the LCD.
When registering a frequency to a memory channel already registered, "Overwrite
OK?" appears on the LCD.
Tips
• By default, 144.000 MHz is registered to the memory channel 1. It can be changed to another
frequency, but not be deleted.
• The frequency which has been registered to a memory channel can be overwritten with a new
frequency.
When you attempt to register a new frequency to a memory channel, an unregistered memory
channel appears.
• To display the lowest unregistered memory number when you register a frequency to a memory
channel, press and hold M over 1 second to enter the Set mode, and then select [3 MEMORY]
[6 MEMORY WRITE].
• To inhibit registration to all memory channels, press and hold M over 1 second to enter the Set
mode, and then select [3 MEMORY]
A Wide Variety of Memory Functions
[4 MEMORY PROTECT].
43