Notification Of A Call From A Remote Station By The Bell; Changing The Number Of Times The Bell Rings - Yaesu FT1DR Operating Manual

Turn O to select [SELECT].
6
Press H.
7
Turn O to select a vibrator operation mode.
8
Remark Default: MODE1
MODE1 The vibrator vibrates continuously.
MODE2 The vibrator operates at long intervals.
MODE3 The vibrator operates at short intervals.
Press p.
9
Sets the Vibrator mode and exits from the Set mode.

Notification of a Call from a Remote Station by the Bell

Set the Bell sound and the blinking b icon on the LCD, to alert you of a call from a
remote station containing a corresponding CTCSS tone or DCS code.
Enter the Set mode:
Press and hold M over 1 second.
1
Turn O to select [4 SIGNALING].
2
Press H.
3
Turn O to select [1 BELL].
4
Press H.
5
Turn O to select [SELECT].
6
Press H.
7
Turn O to select [BELL].
8
When the tone squelch or DCS function is turned on, the
b icon appears.
Press p to set the bell function and exit Set mode.
9
Tip To turn off the bell function, select [OFF] in step 6.
Tips
• To use the bell function, turn on the tone squelch or DCS
function.
• The bell function cannot be used via the repeater.
• The b icon appears when the bell function is turned on.
Upon receipt of a signal from a remote station, the b icon blinks.

Changing the Number of Times the Bell Rings

Enter the Set mode:
Press and hold M over 1 second.
1
Turn O to select [4 SIGNALING].
2
Press H.
3
Using the Tone Squelch Function
89