Disabling Reception While No Signal Is Received Reception Save Function; Changing The Frequency Step Manually; Setting Clock Time; Restricting The Continuous Transmission Time Tot Function - Yaesu FT1DR Operating Manual

Disabling reception while no signal is received
Reception Save Function
To reduce power consumption, the reception function can be turned off when not
receiving a signal.
Enter the Set mode:
Press and hold M for over 1 second.
1
Turn O to select [8 CONFIG].
2
Press H.
3
Turn O to select [17 SAVE RX].
4
Press H.
5
Turn O to select the time.
6
Select the time for the reception to be turned off
automatically.
0.2 SEC (1:1) to 1.0 SEC (1:5)
to 1.0 SEC (1:5) to 10 SEC (1:50)
to 1.0 sec (1:50) to 60 sec (1:300 sec)
OFF
Remark Default: 0.2 sec (1:1)
Press p to save the Reception Save function setting, and exit the Set mode.
7

Changing the frequency step manually

Frequency step can be set so that it can be changed manually.
For more details, see "Changing the Frequency Step Manually" on page 37.

Setting clock time

Set the time for the internal clock of this transceiver.
For details, see "Setting clock time" on page 34.
Restricting the continuous transmission time
TOT Function
Set the transceiver to automatically return to the receive mode after transmitting
continuously for a certain period of time. Accidental transmission of unnecessary
signals, and unwanted battery power consumption can be prevented (time-out timer
function).
Enter the Set mode:
Press and hold M for over 1 second.
1
Turn O to select [8 CONFIG].
2
Press H.
3
(Step: 0.1 sec)
(Step: 0.5 sec)
step 5 sec
Set Mode
135