Setting The Resumption Time Of Radio Reception - Yaesu FT1DR Operating Manual

Dual Reception (DW) Function
Tips
• For broadcast station frequencies, refer to "Preset Broadcast Station Frequencies List (See page
54)" or a commercially sold frequencies list.
• AF-DUAL reception function can be used for the radio frequency registered to the memory bank.
• Pressing T while a signal is being received, will switch to receiving the standby reception
frequency.
• With the AF-DUAL Function, an A Band or B Band registered with a AM broadcast (middle wave
frequency) or a FM broadcast frequency, set for standby reception, cannot be simultaneously
received while listening to the radio.
• To disable the AF-DUAL Function, press F and then 6.
The frequency registered to the standby (memory channel) appears on the LCD.
O Setting the resumption time of radio reception
While receiving radio broadcast (active side) and ham radio band (A-band or B-band) on
standby side, the transceiver may be set to resume receiving the broadcast audio [After
loss of receive signal] or [After transmission].
Press and hold M for over 1 second to enter the Set
1
mode.
Turn O to select [2 TX/RX].
2
Press H.
3
Turn O to select [3 AUDIO].
4
Press H.
5
Turn O to select [3 RX AF DUAL].
6
Press H.
7
Turn O to select reception time.
8
Set transmission time as well.
Transmission and reception for 1 second to 10 seconds,
HOLD (Fixed), or transmission for 1 second to 10 seconds.
Remarks Default setting: transmission and reception for 2 seconds
Display
Transmission and
reception: 1 second
to 10 seconds
Fixed
78
While receiving radio broadcast and ham radio band frequencies (A-band
and B-band) on standby simultaneously with [AF-DUAL Reception
Function], resumption of receiving radio broadcast can be set to [After
loss of receive signal] or [After transmission]. For example, if 5 seconds
is selected, radio reception resumes after 5 seconds after reception (or
transmission) ends.
While receiving radio broadcast and ham radio band frequencies (A-band
and B-band) on standby simultaneously with [AF-DUAL Reception
Function], the transceiver will continue to receive a signal over that
frequency after signal detection without switching back to radio broadcast.
Operation