Yaesu FT1DR Operating Manual page 99

Set mode option No./
setting Item
8-13 PTT DELAY
8-14 RPT ARS
8-15 RPT SHIFT
8-16 RPT SHIFT FREQ
8-17 SAVE RX
8-18 STEP
8-19 DATE & TIME ADJ Set up the built-in clock function.
8-20 TOT
8-21 VFO MODE
8-22 VIBRATOR
9 APRS
9-1 APRS AF DUAL
9-2 APRS
DESTINATION
9-3 APRS FILTER
9-4 APRS MODEM
9-5 APRS MSG FLASH
Description of function
Set the PTT delay time.
Turn the ARS function on/off.
Select a repeater shift direction.
Select a repeater shift width.
Set the reception save time.
Select a channel step.
Set the timeout timer.
Select the frequency selection
range in the VFO mode.
Select a vibrator mode and set
up the vibrator function.
Turn on/off the muting function
when both the APRS function
and AF dual function are active.
Displaying Model Code
Select filter function
Set the APRS baud rate
Set the strobe to flash when there
is an incoming message.
Setting Item
(Bold letters: Default)
OFF / 20ms / 50ms / 100ms /
200ms
ON / OFF
Differs depending on frequency
Differs depending on frequency
OFF / 0.2 SEC (1:1) to 60.0 SEC
(1:300)
AUTO / 5.0 kHz to 100 kHz
–
OFF / 30 SEC to 10 MIN 3.0min
ALL / BAND
MODE:
OFF / BUSY / SIGNALING
SELECT:
MODE1 / MODE2 / MODE3
ON / OFF
APY01D (Cannot be edited.)
Mic-E: ON / OFF
POSITION: ON / OFF
WEATHER: ON / OFF
OBJECT: ON / OFF
ITEM: ON / OFF
STATUS: ON / OFF
OTHER: OFF / ON
ALTNET: OFF / ON
OFF / 1200bps / 9600bps
MSG:
OFF / 2-4-10 (2sec interval) /
20sec / 30sec / 60sec /
CONTINUOUS /
EVERY 2s-10s (1sec interval) /
EVERY 10s-EVERY 50s
(10sec interval) / EVERY
1m-EVERY 10m (1min interval)
GRP:
OFF / 2-4-10 (2sec interval) /
20sec / 30sec / 60sec /
CONTINUOUS
BLN:
OFF / 2-4-10 (2sec interval) /
20sec / 30sec / 60sec /
CONTINUOUS
Set Mode
Reference
page
133
133
134
134
135
37
34
135
136
88
–
–
–
–
–
99