Calling Only A Specific Station New Pager Function; Flow Of Operation To Use The Pager Function - Yaesu FT1DR Operating Manual

Using the Tone Squelch Function
Turn O to select [1 BELL].
4
Press H.
5
Turn O to select [RINGER].
6
Press H.
7
Turn O to select the number of times the bell rings.
8
Remark Default: Once
Tip You can select the number of times the bell rings from among 1
to 20 times, or continuous.
Press p to set the selected number of times the bell rings
9
and exit from the Set mode.
Calling Only a Specific Station
When using the transceivers with your friends, specifying personal codes (each code
composed of two CTCSS tones) allows you to call only a specific station. Even if the
called person is not near his or her transceiver, the information on the LCD indicates
that he or she has been called.
Three persons A, B, and C
are using the transceiver.

Flow of Operation to Use the Pager Function

90
Mr. C sends the personal
code of Mr. B.
Set the same code as that of the remote station.
Determine a frequency.
Perform transmission/reception.
Confirm reception according to the information
on the LCD and the bell sound.
New Pager Function
I'm going
to call
Mr. B.
Ring,
ring,
ring
Only Mr. B is called.