Being Called By The Remote Station (Standby Operation) - Yaesu FT1DR Operating Manual

Being Called by the Remote Station (Standby Operation)

If you use the new pager function on the same frequency as the remote station, the
[PAG] icon displayed on the LCD changes to [PIN], alerting that you have been called by
the remote station. In addition, if you turn on the "bell function" (See page 89), you can
confirm a call from the remote station by the [PAG] display, the blinking [b] icon, and
the bell sound. Also, if you turn on the "vibrator function" (See page 88), the vibrator will
confirm a call from the remote station.
Tip
Selecting [4 SIGNALING]
transceiver in the transmission mode (for about 2.5 seconds) when called by the remote party, and
notifies the remote party to get ready for communication.
When called
[9 PAGER ANS-BACK]
Using the Tone Squelch Function
[ON] in the Set mode automatically places the
Blinks
93