Memory Bank Link Scan - Yaesu FT1DR Operating Manual

Using the Scanning Function
• Turn O clockwise: Scanning is performed toward higher memory channel numbers.
Tips
Turn O counterclockwise: Scanning is performed toward lower memory channel numbers.
• When a signal is received during scanning, scanning stops for 5 seconds and this frequency
is received.
• When scanning is suspended, the decimal point blinks and the LCD stays lit.
• After receiving the frequency for 5 seconds, scanning resumes.
• To stop scanning, press p.
• You can select the range for scanning by selecting [5 SCAN]
mode.

Memory Bank Link Scan

During regular memory bank scanning, only the
memory channels assigned to the recalled memory
bank are scanned. During memory bank link
scanning, memory channels registered in two or
more previously specified banks can be scanned.
Press V to enter the Memory mode.
1
Press B to enter Recall a memory bank.
2
Press F and then B.
3
Turn O to select a memory bank.
4
Select a memory bank subject to memory bank link scanning.
Press V to select a Memory bank link.
5
The memory bank number changes from [B] to [b],
indicating that the bank link has been activated
6
Repeat steps 4 to 5 to select another memory bank.
Press B.
7
The memory banks subject to memory bank link scanning
are determined.
Press F and then [2].
8
Scanning (SCAN) is performed toward higher memory channel numbers.
• Turn O clockwise.: Scanning is performed toward higher memory channel numbers.
Tips
Turn O counterclockwise: Scanning is performed toward lower memory channel numbers.
• When a signal is received during scanning, scanning stops for 5 seconds and this frequency
is received.
• When scanning is suspended, the decimal point blinks and the LCD stays lit.
• After receiving the frequency for 5 seconds, scanning resumes.
• To stop scanning, press p.
• You can select the range for scanning by selecting [5 SCAN]
mode.
62
[5 SCAN WIDTH] in the Set
BANK1
BANK24
The memory bank number
changes from [B] to [b].
[5 SCAN WIDTH] in the Set
BANK10