Turning Illumination Off When Scanning Stops Scan Lamp Function; Setting The Time To Resume Scan Scan Re-Start Function - Yaesu FT1DR Operating Manual

Turn O to select [1 DW TIME].
4
Press H.
5
Turn O to select the monitoring interval.
6
Interval can be selected from 0.1 SEC to 10 SEC.
Remark Default: 5 seconds
Press p to save the priority memory channel monitoring
7
interval setting and exit the Set mode.
Turning illumination off when scanning stops
SCAN LAMP Function
You can set the backlight of LCD to turn ON or OFF when a signal is received during
scanning.
Enter the Set mode:
Press and hold M for over 1 second.
1
Turn O to select [5 SCAN].
2
Press H.
3
Turn O to select [2 SCAN LAMP].
4
Press H.
5
Turn O to select [OFF].
6
ON: The LCD backlight will light when a signal is received.
OFF: The LCD backlight will not light when a signal is
received.
Remark Default: ON
Press p to save the backlight ON or OFF setting when
7
scanning stops, and exit the Set mode.
Setting the time to resume scan
SCAN RE-START Function
You can set the time to resume scanning after a signal is received during scanning.
Enter the Set mode:
Press and hold M for over 1 second.
1
Turn O to select [5 SCAN].
2
Press H.
3
Set Mode
123