Names And Functions Of Controls - Yaesu FT1DR Operating Manual

Names and Functions of Controls

a Antenna terminal (SMA)*
b Flashlight (White LED)
• This LED can be used as a small flashlight in a
dark place.
c A-band BUSY/TX lamp
B-band BUSY/TX lamp
These lamps light green during reception and red
during transmission.
d p PTT switch
• While p switch is being pressed: Transmission.
• The Set mode ends when p switch is pressed
during the Set mode.
e T switch
USA/EXP version
While T is being pressed: Squelch OFF
European version
While T is being pressed: T.CALL (1750 Hz)
f v switch
• While pressing v, turn O: Volume level
adjustment
• Pressing v during the sound is being muted
cancels the Mute function.
g P Power switch
• Press and hold P over 1 second: Power on.
• Press and hold P over 1 second again:
Power off.
• Press P : Key lock
h A key (switching between operating bands)
• Pressing A each time switches between
A-band and B-band.
• Press and hold A over 1 second: Changes
the Dual Band Reception mode to the Mono
Band Reception mode.
• While operating the transceiver in the Mono
Band Reception mode, press F and then
A: Zooms in the display view.
12
i M key
• Pressing M each time switches between the
Frequency and BACKTRACK screen.
• Press and hold M over 1 second: Enters the
Set mode.
j Battery pack*
k O
Turn this dial to change the reception frequency or
select a memory channel.
l GPS antenna
m MIC/SP jack*
Connect a speaker microphone or earpiece
microphone to this jack.
It is not waterproofed when an external
microphone is connected.
Do not connect any microphone which is
not specified by Yaesu. A failure can result.
n EXT DC IN jack*
• When charging the battery pack, connect the
battery charger (PA-48 or SAD-11B) to this jack.
• In the USA/EXP market, connect an external
power supply adapter with a cigarette lighter
plug (E-DC-5B) or an external power cable
(E-DC-6) to this jack.
Do not connect any battery charger which
is not specified by Yaesu. A failure can
result.
o
DATA terminal*
• Use this terminal when using a clone function or
updating the firmware.
• Connect the optional camera-equipped
microphone (MH-85A11U).
• For how to update the firmware, access our
home page.
p Microphone
q Display
This LCD displays reception frequencies and
various settings.
r Speaker
s 15 keys
These keys are used to specify reception/
transmission frequency or select a function.
t F switch
• Press F Function switch
• Press and hold F over 1 second: Registers a
frequency to a memory channel.
* When the included antenna and battery pack
are installed and the MIC/SP jack, EXT DC
IN jack, DATA terminal, and micro SD slot are
securely covered with rubber caps, the FT1DR/
DE meets the waterproofing performance
conforming to IPX5 (See page 11).