Tips
To cancel a skip/selected memory channel, select [OFF].
When it is canceled, the
Skip memory
channel
[SKP]
Scanning Only the Selected Memory Channel
1
Switch to the Memory mode, and then recall the selected
memory channel.
Press F and then 2.
2
Tips
• Scanning (SCAN) is performed toward higher memory
channel numbers.
• Only the selected memory channel is scanned.
• If a signal is received during scanning, a beep is emitted and scanning stops for 5 seconds
to receive the current frequency.
• When scanning is suspended, the decimal point blinks and the LCD stays lit.
• After receiving the frequency for 5 seconds, scanning resumes.
• To cancel scanning, press p.
• You can select the range for scanning by selecting [5 SCAN]
mode.
Scanning a Memory Bank
Only the memory channels in the recalled memory bank can be scanned.
Press V to enter the Memory mode.
1
Press B to enter Recall a memory bank.
2
Pressing B each time toggles between [MEMORY NO] and [BANK (No.)].
To recall another memory bank, press F and then B.
Tips
Turn O to select a memory bank.
3
Select a memory bank from BANK1 through BANK 24.
Press B.
4
The selected memory bank is determined.
Press F and then 2.
5
Scanning (SCAN) is performed toward higher memory channel numbers.
icon on the LCD disappears.
O
Selected memory
channel
[SELECT]
OFF
Using the Scanning Function
Lights when a skip memory
channel is specified
Blinks when a select
memory channel is specified
[5 SCAN WIDTH] in the Set
61