Selecting A Frequency Band - Yaesu FT1DR Operating Manual

Selecting a Frequency Band

You can select a frequency band to use for the A-band and B-band separately.
O Setting a Frequency Band for the A-band
Press A to select the A-band.
1
Press B repeatedly to select a frequency band.
2
AM BC
Band
Cellular Blocked
USA version
Pressing F and then B changes frequency bands shown above in the reverse order.
Tip
O Selecting a Frequency Band for B-band
Press A to select the B-band.
1
Press B to select a frequency band.
2
AIR band
470MH to 580MHz
Pressing F and then B changes frequency bands shown above in the reverse order.
Tip
Caution
z Digital communication can be performed only on the A-band.
Digital communication cannot be performed on the B-band.
Tips
• The frequency settings from the factory are:
A-band: 144.000 MHz
• The factory setting of the Auto mode is set such that the transceiver is automatically switched to the
optimal reception mode for the default frequency bands.
To change the default reception mode, press and hold M for over 1 second and then select [2 TX/
RX] [1 MODE]
• For the relationship between frequency bands and reception frequencies, see the table on page 28.
• You can also recall the home channel of each frequency band by pressing F and then 4 (See
page 45).
FM BC Short Wave
Band Band
UHF-TV
Band
144 MHz band
430 MHz band
B-band: 430.000MHz
[4RX MODE] (See page 38).
Performing Communication
50 MHz
band
430 MHz Information radio
band band (1)
Information radio band (1)
144 MHz
AIR band
band
VHF-TV
Band
VHF-TV Band
29