Notification Of A Call From A Remote Station By The Bell Function; User Programmed Reverse Ctcss Decoder - Yaesu FT3DR Advanced Manual

Notification of a Call from a Remote Station by the Bell Function

The Bell may be set to sound an Alert when a call from another station containing a cor-
responding tone, DCS or pager code is received. " " icon on the display blinks to pro-
vide a later notice of the call from the other station.
1. Press and hold the [DISP] key  touch [SIGNALING]  [1 BELL].
2. Press the [DISP] key.
3. Rotate the DIAL knob to select "BELL".
4. Press the [BACK] key, and then rotate the DIAL knob
to select "RINGER", and then press the [DISP] key.
5. Rotate the DIAL knob to select the desired number of
times (1-20 times or continuous) the Bell rings.
• • • 1time ↔ 2times ↔ • • • ↔ 20times ↔ CONTI • • •
6. Press the PTT switch to save the setting and return to normal operation, and the " "
icon appears on the display.
If the setting is "CONTI" (continuous), the bell keeps sounding until an operation is made.

User Programmed Reverse CTCSS Decoder

The tone signal frequency can be set at 100 Hz intervals between 300 Hz and 3000 Hz
to mute the audio when receiving a signal containing a CTCSS tone matching the pro-
grammed tone.
1. Touch [F MW]  [SQTYP].
2. Rotate the DIAL knob to select "PR FREQ".
3. Press the PTT switch to save the setting and return to
normal operation.
4. Touch [F MW]  [CODE].
The setting screen containing the CTCSS tone fre-
quencies is displayed.
5. Rotate the DIAL knob to select the desired CTCSS
tone frequency.
300Hz to 3000Hz (100Hz steps)
6. Press the PTT switch to save the setting and return to
normal operation.
12
1 BELL
SELECT : BELL
RINGER : 1time
7 PR FREQUENCY
1600Hz