Receiving "Pager Code" Calls From A Remote Station (Standby Operation); Notification Of A Call From A Remote Station By The Bell Function - Yaesu FTM-200DR Advance Manual

9. Rotate the DIAL knob to select the TX CODE 1 of the
codes from 01 to 50.
10. Press the DIAL knob or the [SQL
11. Rotate the DIAL knob to select [TX CODE 2] then press
the DIAL knob.
12. Rotate the DIAL knob to select the TX CODE 2 of the
codes from 01 to 50.
The same code cannot be used for TX CODE 1 and TX
CODE 2.
13. Press any key (except Power Switch) or PTT switch to
finish the setting and return to the original screen.
14. Press the PTT switch to transmit a call to the specific
station.
• The reverse combination works as the same code, that is "05 47" is the same as "47 05".
• If the same code is specified for all individuals, all the individuals can be called at the same
time.
• The default code is "05 47".
• When receiving the codes, the sound of the tones may be heard intermittently.

Receiving "Pager Code" calls from a Remote Station (Standby Operation)

When the Pager function is activated, the audio of received calls with a corresponding
Pager Code is heard.
Furthermore, when the Bell function (see below) is activated, the bell rings when receiving
calls from the other station.

Notification of a Call from a Remote Station by the Bell Function

The Bell may be set to sound an Alert when a call from another station containing a cor-
responding tone, DCS or pager code is received.
1. Press and hold the [F
2. Rotate the DIAL knob to select the desired number of
times (1 - 8 times or continuous) the Bell rings.
OFF/ 1 time / 3 times / 5 times / 8 times / CONTINUOUS
If the setting is "CONTINUOUS", the bell keeps
sounding until an operation is made.
3. Press any key (except Power Switch) or PTT switch to finish the setting and return to
the original screen, the "
] key.
BACK
] key  [47 BELL RINGER]  Press the DIAL knob
MENU
" icon appears on the display.
13
SIGNALING
44 SQL EXPANSION
45 PAGER CODE
46 PQ FREQUENCY
47 BELL RINGER
OFF
>