Notification Of Call From A Remote Station By The Bell; Calling Only A Specific Station New Pager Function; Flow Of Operation To Use The Pager Function - Yaesu FTM-400DR Operating Manual

Notification of Call from a Remote Station by the Bell

Call from a remote station (reception of a signal containing a coincident tone or DCS)
can be notified by the bell sound and the b icon blinking on on screen.
1
Press and hold M over 1 second.
The Setup Menu appears.
2
Tap [SIGNALING].
3
Tap [7 BELL RINGER].
The set value for BELL RINGER appears in orange.
4
Turn the O to select a number of times the bell
rings.
The number of times the bell rings changes in the
following order, each time O is rotated.
[OFF] → [1time] → [3times] → [5times] → [8times] →
[CONTINUE]
5
Press O shortly.
The number of times the bell rings is set and appears in green.
6
Press and hold M over 1 second.
Returns to the previous screen.

Calling Only a Specific Station New Pager Function

When using FTM-400DR with your friends, specifying personal codes (each code is
composed of two CTCSS codes) allows only a specific station to be called. Even if the
called person is not near his or her FTM-400DR, the information on the screen indicates
that he or she has been called.

Flow of Operation to Use the Pager Function

48
Set the same code as that of the remote station.
Determine a frequency.
Perform transmission/reception.
Confirm reception according to the information on
the screen and the bell sound
F C C I D : K 6 6 2 0 3 4 5 X 4 0
I C : 5 1 1 B - 2 0 3 4 5 X 4 0