Locking Keys And Switches; Restoring To Defaults (All Reset) - Yaesu FT1DR Operating Manual

Locking keys and switches

To prevent accidental frequency change during operation, keys, switches and O
except p switch, T, v, P can be locked.
Press P to lock the keys and switches.
1
l appears on the LCD.
To unlock a key or switch, press P again.
Remark
l disappears from the LCD.
Tip
• You can also lock the O and p switch by selecting the Set mode option [8 CONFIG]

Restoring to Defaults (All Reset)

You can restore all transceiver settings and memory content, such as memory channels,
to the defaults.
Press P while pressing %, D, and H.
1
The transceiver is turned on, followed by beep.
When you hear the beep, release the keys.
2
When "ALL RESET PUSH F KEY!" appears on the
LCD, press F.
A beep sounds and the callsign input screen appears
on the LCD.
3
Input a callsign for your transceiver.
Input the callsign with the numeric keys.
Press p to save your callsign and the screen returns to
4
the frequency display.
Remark To cancel the All Reset function, press a key or switch
other than F.
Caution
When the All Reset function is performed, all data such as memory channels registered in the memory
is deleted. Be sure to write it down on paper or back up the data on the microSD memory card (See
pages 137 to 138).
Tip
To return only the Set Mode option settings to default, press P while pressing % and V.
Miscellaneous Settings
[9 LOCK].
39