Selecting A Reception Method When Scanning Stops; Memory Channel Scanning - Yaesu FT1DR Operating Manual

Selecting a Reception Method When Scanning Stops

When scanning stops, you can select one of the following three reception methods:
(1) The signal is received for the specified period of time, and then scanning resumes.
You can specify this period of time in steps of 0.5 second within the range from 2 to
10 seconds.
(2) The signal is received until it fades out. Two seconds after the signal fades out,
scanning resumes. [BUSY] appears on the LCD.
(3) Scanning stops and the current frequency is received. [HOLD] appears on the LCD.
Press and hold M for over 1 second.
1
Turn O to select [5 SCAN].
2
Press H.
3
Turn O to select [4 SCAN RESUME].
4
Press H.
5
Press H again.
6
Turn O to specify the reception method.
7
Select a reception method from [2 SEC TO 10 SEC (0.5
SEC STEP)], [BUSY], and [HOLD].
Press p to save the specified reception method and exit
8
from the Set mode.
Tips
• The reception method selected here is also applied to [VFO Scanning], [Programmable Memory
Channel Scanning] and [Memory Channel Scanning].
• The scanning restart time after BUSY (duration of signal reception) can be changed by selecting the
Set mode option [5 SCAN RESTART]

Memory Channel Scanning

Frequencies registered to the memory channels can be scanned in the order of memory
channel number.
1
Switch to the Memory mode and recall a memory channel.
Press F and then 2.
2
Scanning (SCAN) is performed toward higher memory
channel numbers.
When a signal is received, the decimal point blinks.
Using the Scanning Function
[3 SCAN RE-START].
When a signal is received,
the decimal point blinks.
59