Specifying A Skip/Selected Memory Channel - Yaesu FT1DR Operating Manual

Using the Scanning Function
• Turn O clockwise.: Scanning is performed toward higher memory channel numbers.
Tips
Turn O counterclockwise: Scanning is performed toward lower memory channel numbers.
• When a signal is received during scanning, scanning stops for 5 seconds and this frequency
is received.
• When scanning is suspended, the decimal point blinks and the LCD stays lit.
• After receiving the frequency for 5 seconds, scanning resumes.
• To stop scanning, press p.
Tips
• Even during scanning, you can adjust the squelch in the following procedure:
Press F Press T.
• During scanning, you can finish the squelch adjustment in the following procedure:
Press F Press T.
• When a memory channel is recalled, the regular memory channels (memory channel numbers
1-900) are scanned.
• When a memory bank is recalled, only the memory channels in the memory bank are scanned.
• For the operation to perform when scanning stops, see [Selecting a Reception Method When
Scanning Stops] on page 59.
• Press and hold M over 1 second to select the Set mode option, and then select the following
setting items for more convenient use:
[8 CONFIG] [3 BEEP]
[8 CONFIG] [3 BEEP]
[5 SCAN] [2 SCAN LAMP]: Prevents the LCD from being lit when scanning stops.
[5 SCAN WIDTH]

Specifying a Skip/Selected Memory Channel

You can specify two types of memory channels, a skip memory channel and a selected
memory channel, for effective memory channel scanning.
Skip memory channel: You can specify a memory channel that need not be scanned
Selected memory channel: You can specify selected memory channels so that only
1
Switch to the Memory mode, and then recall the memory
channel you want to specify as a skip memory channel or a
selected memory channel.
Press and hold M over 1 second.
2
Enters the Set mode.
Turn O to select [3 MEMORY].
3
Press H.
4
Turn O to select [5 MEMORY SKIP].
5
Press H.
6
Turn O to select [OFF], [SKIP], or [SELECT].
7
Press p to save the setting and exit from the Set mode.
8
60
Turn O to adjust the squelch.
[EDGE]: Emits a beep when the frequency band edge is reached.
[SELECT]: Prevents a beep from being emitted when scanning stops.
[5 SCAN]: Range for scanning can be selected.
during memory channel scanning.
the specific memory channels are scanned during memory
scanning.