[DCS SEARCH] appears on the LCD.
The transceiver starts to search for the DCS code.
When a corresponding DCS code is detected, a beep is
emitted and searching stops temporarily. The detected
DCS code blinks.
To stop searching, touch [STOP].
To set the searched DCS code,
Touch [STOP]. → Hear the beep sound. → Gently press the
The transceiver exits from Set mode.
For setting how the transceiver operates when scanning stops, see "Setting the Receive Operation
When Scanning Stops" on page 74.
Notification of a Call from a Remote Station by Vibration
Set the vibrator to alert you of a call from a remote station containing a corresponding
tone or DCS code.
Press and hold the
The transceiver enters Set mode.
Touch [22 VIBRATOR].
Rotate the DIAL to select [MODE], then press the
Rotate the DIAL to select [SIGNALING].
The vibrator setting is set and the transceiver exits from the Set mode.
To deactivate the vibrator function, select [OFF] in step 5.
key for over one second.
Using the Tone Squelch Function
key 3 times.