Tips
• You can change the unit of GPS data by selecting [9 APRS]
• When the GPS function is used, the accurate time data (date and time) obtained from GPS
appears on a 24 hour basis. This time data is reflected in the time data displayed on the GPS and
APRS screens.
• You can change the geodetic system of the built-in GPS unit by selecting [9 APRS]
DATUM] in the Set mode. However, since APRS uses the geodetic system of WGS-84, it is
recommended not to change it.
• You can set the time zone by units of 30 minutes by selecting [9 APRS]
Set mode (Default: Japanese time zone).
• When the GPS function is active, the power consumption increases by about 30 mA. As a result,
the battery life is reduced by about 20% compared to when the GPS function is deactivated.
• You can obtain position information from a external GPS device by selecting [9 APRS]
COM PORT SETTING] and then setting [INPUT] to [GPS] in the Set mode. In this case, the data
obtained from the internal GPS is disabled.
• When using an external GPS device, keep it away from the transceiver.
Smart Navigation Function
Using the Smart Navigation Function
There are 2 methods of navigation with the Smart Navigation function.
(1) Real-time navigation function
(2) Backtrack function
O Real-Time Navigation Function
GPS position information and voice signals are simultaneously transmitted in the V/D
mode of C4FM digital.
For this reason, the position and direction of the remote station can be displayed in real-
time even during communication.
Press M to open the GPS screen.
1
Turn O to select [YR].
2
The distance and direction to the remote station operating on the same frequency in
the V/D mode is displayed.
Direction display
Press M.
3
The screen returns from the navigation screen to the normal frequency display.
Explanation of GPS Screen and Operation
Display of remote station position
[22 GPS UNIT] in the Set mode.
[19 GPS
[28 TIME ZONE] in the
Distance to remote station
[17
73