Searching For The Frequency Of The Tone Squelch Used By The Remote Station; Selecting A Dcs Code - Yaesu FT1DR Operating Manual

Using the Tone Squelch Function
Searching for the Frequency of the
Tone Squelch Used by the Remote Station
The frequency of the tone squelch used by the remote station can be searched for and
displayed.
Enter the Set mode:
Press and hold M for over 1 second.
1
Turn O to select [4 SIGNALING].
2
Press H.
3
Turn O to select [11 SQL TYPE].
4
Press H.
5
Turn O to select [TONE SQL].
6
Press M.
7
Turn O to select [12 TONE SQL FREQ].
8
Press H.
9
10
Receive the signal from the remote station.
Press and hold B over 1 second.
11
[TONE SEARCH] appears.
Release B.
12
Search for the tone frequency starts.
When a corresponding tone frequency is detected, a beep
is emitted and search stops temporarily. The detected tone
frequency blinks.
Tip To set the searched tone frequency and exit from the Set mode:
Press B
Tip
For the operation to perform when scan stops, refer to "Selecting a Reception Method When Scanning
Stops" on page 59.

Selecting a DCS Code

You can select a DCS code from among 104 DCS codes (023 to 754).
1
Specify the operating frequency.
Press and hold M over 1 second to enter the Set mode.
2
Turn O to select [4 SIGNALING].
3
Press H.
4
Turn O to select [2 DCS CODE].
5
Press H.
6
86
Quickly press M 3 times.
a beep is emitted.