Searching For The Frequency Of The Dcs Used By The Remote Station - Yaesu FT1DR Operating Manual

Turn O to select a DCS code.
7
Quickly press M 3 times to set the DCS code and exit
8
from the Set mode.
Tip
By default, the DCS code is set to [023].

Searching for the Frequency of the DCS Used by the Remote Station

The DCS code used by the remote station can be searched for and displayed.
Enter the Set mode:
Press and hold M over 1 second.
1
Turn O to select [4 SIGNALING].
2
Press H.
3
Turn O to select [11 SQL TYPE].
4
Press H.
5
Turn O to select [DCS].
6
Sets the DCS.
Press M.
7
Turn O to select [2 DCS CODE].
8
Press H.
9
10
Receive the signal from the remote station.
Press and hold B over 1 second.
11
[DCS SEARCH] appears.
Release B.
12
Searching for the DCS code begins. When a corresponding
DCS code is heard, a beep is emitted and search stops
temporarily. The found DCS code blinks.
Tip To set the searched DCS code:
Press B
to set the DCS code and exit from the Set mode.
Tip
To perform the operation when scan stops, refer to "Selecting a Reception Method When Scanning
Stops" on page 59.
Quickly press M 3 times
a beep is emitted.
Using the Tone Squelch Function
87