Turning Off The Power Automatically Apo Function - Yaesu FT1DR Operating Manual

Turn O to select the range for scanning.
12
Mode Display*
ALL
VFO Mode
BAND
ALL CH
Memory
Mode
BAND
*1 For the relationship between frequency bands and reception frequencies, see the table at the
bottom of page 28.
Press p to save the range for scanning, and exit the Set mode.
13
Turning off the power automatically
APO Function
The transceiver may be set to turn off automatically if there is no operation for a certain
period of time.
Enter the Set mode:
Press and hold M for over 1 second.
1
Turn O to select [8 CONFIG].
2
Press H.
3
Turn O to select [1 APO].
4
Press H.
5
Turn O to set the time.
6
Set the time for the transceiver to turn off automatically in
steps of 30 minutes.
OFF/30 MIN/1 HOUR to 12 HOURS
Remark Default: OFF
Press p to save the auto power-off function setting, and
7
exit the Set mode. The transceiver will be automatically
turned off if there is no operation for the set period of time.
Scans all bands within the range from the current frequency to 108-999
MHz.
Scans the current band (see the table on the next page) starting with the
current frequency.
Scans all memory channels (1-900) of the currently selected memory
channel. When selected memory channels are specified, all of them are
scanned (See page 59).
Scans only the memory channels to which frequencies in the same
1
frequency band* are registered. When the selected memory channels
are specified, scans only the selected memory channels to which
frequencies in the same frequency band
Operation Status
*1
are registered (See page 61).
Set Mode
125