Repeater Operation; Communicating Via The Repeater; Tone Calling (1750 Hz) - Yaesu FT1DR Operating Manual

Repeater Operation

Communicating Via the Repeater

The transceiver includes an ARS (Automatic Repeater Shift) function which permits
communication through the repeater automatically just by setting the receiver to the
repeater frequency.
1
Set the receive frequency to the repeater frequency.
" " or " " appears in the upper right corner of the
LCD.
Press p, to begin communicating through the
2
repeater.
Tips
• Pressing F and then pressing 5 enters the "reverse" state where the transmit frequency
and the receive frequency are temporarily reversed. This allows you to check and find if direct
communication with the remote station is possible.
• In the "reverse" state, [ ] blinks on the LCD.
• Pressing F again and then 5 exits the "reverse" state.
• Press and hold M over 1 second to enter the Set mode and change the options to allow more
convenient use of this function.
[8 CONFIG] [14 RPT ARS] You can deactivate the ARS function.
[8 CONFIG] [15 RPT SHIFT] You can set the repeater shift direction.
[8 CONFIG] [16 RPT SHIFT FREQ] You can change the repeater shift step.

Tone Calling (1750 Hz)

If your transceiver is FT1DE (European version), press and hold in the T switch
(just below the p switch) to generates a 1750 Hz burst tone to access the European
repeater. The transmitter will automatically be activated, and a 1750 Hz audio tone will
be superimposed on the carrier. Once access to the repeater has been gained, you may
release the T switch, and use the p switch for activating the transmitter thereafter.
If you need to access the repeaters which requires a 1750 Hz burst tone for access by
the FT1DR (USA/EXP versions), you can set the T switch to serve as a "Tone Call"
switch instead. To change the configuration of this switch, use Set Mode [8 CONFIG]
[10 MONI/T-CALL].
40
Repeater Operation