Table of Contents
Advertisement
How to Use This Manual
Operation Procedures
In this manual, the following marks are used in the explanation of the operation procedures, cautions, notes, and related
functions.
Indicates that this is a note concerning operation or an explanation
of a related function.
Indicates a hard key on the right side of the control panel.
Indicates the title of the topic being explained on this page.
Gloss Adjustment
If the power is not turned ON, see "Turning On
the Power" on p.2-2.
If the copier is in standby mode, press the
(Standby) key so that the screen shown at right
is displayed.
To adjust the copy exposure, press the
or the
key.
Indicates a key shown on the
touch panel display.
Remove any paper clips from the original before
placing it on the platen glass. The copier can be
damaged by foreign objects falling inside of it.
Indicates a note either containing information you should be
aware of regarding the operation, or an explanation of
restrictions. Always read these items in order to operate the
copier properly.
Indicates a function that can be used when the copier is
equipped with the optional Feeder.
Indicates a function that can be used when the copier is
equipped with the optional ED board.
Indicates the title and page number of a reference item.
Indicates a step in the operation procedure.
1.
Press the
key
2.
Press the GLOSS ADJUSTMENT key.
3.
Place the original on the platen glass.
(The page depicted above is for example purposes only, and is not actually found in this manual.)
Indicates options, etc., required in order to use this function. (Refer
Indicates a key on the left side of the Control panel.
key.
Shows the touch panel
display screen.
Illustration of operation
Indicates a function that can be used when the copier is
equipped with the optional Editor.
to the explanation at the bottom of this page.)
V
Advertisement
Table of Contents
