Table of Contents
Advertisement
Changes to location and changes to size can
not be carried out at the same time.
For horizontal direction, correction values to the
left are displayed by "+", and correction values to
the right are "–".
For the vertical direction, correction values up
are displayed by "–", and correction values down
are "+".
Changes to the location are used when the
designated size was correct, but the copy was
made with the position off-set. Corrections only to
the area can be made without moving the original
on the platen glass.
The width of movement is calculated as follows.
5mm
Edited area
5mm
Designated area
In this case, shift the original 5 mm to the left and 5
mm down.
If the SHIFT AREA key is pressed, the screen
returns to the Area Shift display.
Size corrections are only made when the
designated area size is not copied correctly.
Corrections only to the area can be made without
moving the original on the platen glass.
Changes can not be made to sizes of Polygon,
Free, Tracing, or enclosed area.
The correction value for the size is calculated as
follows.
5mm
Designated area
5mm
Edited area
In the case, enlarge the original –5 mm to the right
and –5 mm up.
Character Composition (Combining Characters from a Black-and-White Original with a Color Original)
5.
Press the key for the number corresponding to the area
you wish to change.
6.
Press the ADJUST AREA key.
7.
Change the area/area size.
Changing the area
Use the eight-direction keys to shift. Objects are shifted in 1 mm steps.
X: Shifted in the horizontal direction.
key to shift right,
Y: Shifted in the vertical direction.
key to shift up,
Changing the area size
1. Press the ENLARGE/REDUCE AREA key.
2. Use the four-direction keys to change the area size.
8.
Press the OK key.
Follow on, continuing the series of operations.
key to shift left.
key to shift down.
4-37
Advertisement
Table of Contents
