Oce Color System 200 Operator's Manual page 150

Changes to location and changes to size can
not be carried out at the same time.
Changes to the location are used when the
designated size is correct, but the copy is made with
the position off-set. Only corrections to the area can
be made without moving the original on the platen
glass.
The width of movement is calculated as follows.
Displacement of the inserted original
5mm
5mm
Area to be inserted
In this case, shift the area to be inserted
5 mm to the left and 5 mm down.
Displacement of the area to be inserted
5mm
5mm
Designated area
In this case, shift the area to be inserted 5 mm to
the left and 5 mm down.
Size corrections are only made when the
designated area size is not copied correctly. Only
corrections to the area can be made without moving
the original on the platen glass.
The correction value for the size is calculated as
follows.
5mm Area to be inserted
5mm
Inserted area
In this case, shift the area to be inserted –5 mm to
the right and –5 mm thereby enlarging the area.
Even if the area is designated correctly, the
image may be cut off, or there may be a blank
space.
Image Composition (Inserting a color Image into a Black-and-White Original)
4-8
Insertion original
Insertion area
4.
Change the position / size of original.
Changing the area position
Use the eight-direction keys to shift. Objects are shifted in 1 mm steps.
X: Shifted in the horizontal direction.
key to shift right,
Y: Shifted in the vertical direction.
key to shift up,
Changing the area size
1. Press the ENLARGE/REDUCE AREA key.
2. Use the eight-direction keys to shift. Objects are shifted in 1 mm
steps.
X: Shifted in the horizontal direction.
key to shift right,
Y: Shifted in the vertical direction.
key to shift up,
5.
Press the OK key.
key to shift left.
key to shift down.
key to shift left.
key to shift down.