Oce Color System 200 Operator's Manual page 121

When an area is designated with a polygon or a
free-hand drawing in which the lines intersect, the
outermost line is recognized as the boundary of the
area.
k
k
When designating a free-hand area or an area
by tracing, points are counted automatically. Areas
requiring 4,000 or more points can not be
recognized. Once 4,000 points have been counted
for an area, that area is no longer recognized.
When drawing areas, the starting point and
ending point should be the same point.
The trace width can be changed as desired
between 1 mm, 2 mm, 3 mm, and 4 mm. (See
p. 7-4 in the Basic Operations Manual.)
When using Coloring, designate a point inside
the enclosed area. If you designate a point on the
line of the enclosed area, Coloring may not be
performed properly.
When designating an enclosed area, make sure
that the border of the image is not broken. Note that
even the borders of originals that are not broken
may become so if the image overlaps the border
when it is enlarged.
Designating polygons
Use the edit pen to enter the corners of the polygon being designated.
Press the SET key to connect the corners.
Designating free-hand areas
Use the edit pen to trace the free-hand area being designated. The area
designation ends when the edit pen breaks contact with the Editor.
Designating an area by tracing
Trace a line with the edit pen on the Editor to have that line recognized
as an area.
Designating an enclosed area
Press the edit pen on one point inside the enclosed area.
There are two types of enclosed areas: DESIG. AREA and
ENTIRE ENCLOSED . After pressing the OK key, select the type of
enclosed area.
DESIG. AREA :
ENTIRE ENCLOSED : The entire area within the outer border is
Area Designation (Using the Edit Pen)
When there is a second border within the first
border, the area that is recognized as the
designated area excludes the area inside the
innermost border.
k
(The "x " indicates the point designated with the
edit pen.)
recognized as the designated area.
k
(The "x " indicates the point designated with the
edit pen.)
3-13