Table of Contents
Advertisement
Area Designation (Using the Edit Pen)
Use the edit pen with this function and designate a specific area of the original for image editing.
There are two methods used for Area Designation.
Rectangular Area Designation:
Non-rectangular Area Designation: This method is used to designate circles, ovals, polygons, and other such areas.
In this manual, both rectangles and squares will be referred to as "rectangles."
There are three editing methods:
Framing:
Copies only the part of the image inside the designated area.
Blanking:
Copies the image with the area inside the designated area blank.
Multiple
Copies the part of the original inside the designated area in a different editing function than that used to copy
Editing:
outside the designated area (the entire original except the designated area). There are fourteen editing
functions:
Single Color
4-full Color/3-full Color
Color Conversion
Color Gradation
Base Color
Framing
Multiple Editing
Only the last previous mode settings can hold area designation information when you press the Recall key. Also, non-rectangular, polygon,
free or trace area settings can not be reproduced.
Area Designation (Using the Edit Pen)
3-6
With the edit pen, designate an area by entering the corner points of two of the opposing
angles of the rectangular area.
k
k
Color Filter
Paint
Text Editing
Texture
Nega/Posi
Blanking
Original Type
Color Balance
Saturation Adjustment
Hue Adjustment
k
Advertisement
Table of Contents
