Teledyne LabMaster 10 Zi Series Getting Started Manual page 130

LabMaster 10 Zi Oscilloscopes
Enabling Pass/Fail Conditions
Beside each Qx button on the main Pass/Fail dialog is an On checkbox.
Use this or the On checkbox on each respective Qx dialog to enable the
specific condition for use.
When each Qx dialogs is configured and enabled as desired, you can turn
on/off all conditions using the Testing checkbox on the Pass/Fail dialog.
Pass/Fail test results are displayed in a table below the grid.
122 922561-00 Rev A