Turning On Traces - Teledyne LabMaster 10 Zi Series Getting Started Manual

Message Bar
At the bottom of the oscilloscope display is a narrow message bar. The
current date and time are displayed at the far right. Status, error, or other
messages are also shown in this area.

Turning On Traces

To turn on a trace, do one of the following:

Press the front panel Channel buttons (1-4).

Press the channel buttons on the front of your Acquisition Modules
to turn channels on/off.

From menu bar, choose Vertical > Channel <#>.
A trace descriptor box appears on the display for each open channel trace.
When you touch this descriptor box, the trace is activated and the Channel
(C#) dialog opens.
A highlighted descriptor box indicates the active trace to which all actions
apply. Touch this box at any time to open its setup dialog.
NOTE
: The default is to display each trace on its own grid automatically (Auto Grid).
To change how traces are arranged, choose another grid option from the Display
menu.
You can also quickly create (and turn on the descriptor box for) math and
memory traces without leaving the Channel dialog by touching the Measure
and Math icons at the bottom.
Whenever you activate a channel, math, or memory trace, the dialog at the
bottom of the screen automatically switches to the appropriate setup dialog
for that selection. The tab is labeled with the corresponding channel
number:
922561-00 Rev A
Getting Started Manual
55