Teledyne LabMaster 10 Zi Series Getting Started Manual page 156

LabMaster 10 Zi Oscilloscopes
address if your network supports DHCP. If it does not, you can assign
a static address in the standard Windows network setup menu.
The Remote Control Assistant monitors communication between your PC
and oscilloscope when you are operating the instrument remotely. You can
log all events or errors only. This log can be invaluable when you are
creating and debugging remote control applications.
Remote Control Setup
If you are connecting the oscilloscope to a network, first contact your
Information Systems administrator. If you are connecting the oscilloscope
directly to your PC, connect a GPIB or Ethernet cable between them.
1.
On the Remote dialog, make a Port selection: TCPIP (transmission
control protocol/Internet protocol) or GPIB (general purpose
interface bus). If you do not have a GPIB card installed, the GPIB
selection will not be accessible.
2.
If you are using GPIB, set a GPIB address by touching inside the GPIB
Address data entry control and provide an address.
OR
If you are using TCPIP, press the Net Connections button; the
Windows Network Connections window opens. You can reconfigure
the oscilloscope's connection if it is already connected to the network
or make a new connection.
NOTE
: Your instrument allows you to restrict remote control access to certain
clients. To restrict access, under
addresses or domain name server names you want to restrict separated by a
comma.
148
Security
, touch the
Yes
button and enter the IP
922561-00 Rev A